Difference between revisions of "DHCP Configuration"
From ERPXE Wiki
| Line 1: | Line 1: | ||
| + | |||
== Use ERPXE DHCP == | == Use ERPXE DHCP == | ||
| − | to | + | ERPXE virtual appliance comes with DHCP server pre installed and configured. |
| + | the DHCP server is disabled for cases that other DHCP exist inside the intranet. | ||
| + | if you want ERPXE to serve DHCP you can enable the Virtual Appliance's DHCP by: | ||
from ERPXE terminal: | from ERPXE terminal: | ||
chkconfig dhcpd on | chkconfig dhcpd on | ||
service dhcpd start | service dhcpd start | ||
| + | |||
== Use Other DHCP == | == Use Other DHCP == | ||
Revision as of 22:41, 12 December 2011
Use ERPXE DHCP
ERPXE virtual appliance comes with DHCP server pre installed and configured. the DHCP server is disabled for cases that other DHCP exist inside the intranet. if you want ERPXE to serve DHCP you can enable the Virtual Appliance's DHCP by:
from ERPXE terminal: chkconfig dhcpd on service dhcpd start
Use Other DHCP
For Custom Installation
if you are setting a custom installation or you already have an DHCP service on your network you should Configure your DHCP server to use ERPXE.
add the following rules to your dhcp server: next-server 10.0.0.1; filename "gpxelinux.0";
rules 66, 67 in microsoft dhcp.
For Virtual Appliance
- Update the virtual appliance's gateway to your current router/gateway.
- ERPXE IP address is 10.0.0.1. To change it you should read Change IP article.
