Difference between revisions of "DHCP Configuration"
From ERPXE Wiki
| Line 10: | Line 10: | ||
=== For Custom Installation === | === For Custom Installation === | ||
| − | if you are setting a custom installation or you already have an DHCP service on your network you should Configure your DHCP server to use ERPXE. | + | if you are setting a custom installation or you already have an DHCP service on your network you should Configure your DHCP server to use ERPXE. |
| + | |||
| + | add the following rules to your dhcp server: | ||
| + | next-server 10.0.0.1; | ||
| + | filename "gpxelinux.0"; | ||
| + | |||
| + | rules 66, 67 in microsoft dhcp. | ||
=== For Virtual Appliance === | === For Virtual Appliance === | ||
Revision as of 22:34, 12 December 2011
Use ERPXE DHCP
to Enable the Virtual Appliance's DHCP:
from ERPXE terminal: chkconfig dhcpd on service dhcpd start
Use Other DHCP
For Custom Installation
if you are setting a custom installation or you already have an DHCP service on your network you should Configure your DHCP server to use ERPXE.
add the following rules to your dhcp server: next-server 10.0.0.1; filename "gpxelinux.0";
rules 66, 67 in microsoft dhcp.
For Virtual Appliance
- Update the virtual appliance's gateway to your current router/gateway.
- ERPXE IP address is 10.0.0.1. To change it you should read Change IP article.
