Difference between revisions of "DHCP Configuration"
From ERPXE Wiki
| Line 16: | Line 16: | ||
add the following rules to your dhcp server: | add the following rules to your dhcp server: | ||
next-server 10.0.0.1; | next-server 10.0.0.1; | ||
| − | filename " | + | filename "pxelinux.0"; |
rules 66, 67 in microsoft dhcp. | rules 66, 67 in microsoft dhcp. | ||
Revision as of 22:21, 5 April 2012
Contents
Use ERPXE DHCP
ERPXE virtual appliance comes with DHCP server pre installed and configured. the DHCP server is disabled for cases that other DHCP exist inside the intranet. if you want ERPXE to serve DHCP you can enable the Virtual Appliance's DHCP by:
from ERPXE terminal: chkconfig dhcpd on service dhcpd start
Use your own DHCP solution
For Custom Installation
if you are setting a custom installation or you already have an DHCP service on your network you should Configure your DHCP server to use ERPXE.
add the following rules to your dhcp server: next-server 10.0.0.1; filename "pxelinux.0";
rules 66, 67 in microsoft dhcp.
for more information read {DHCP Configuration}
For Virtual Appliance
- Update the virtual appliance's gateway to your current router/gateway.
- ERPXE IP address is 10.0.0.1. To change it you should read Change IP article.
