Difference between revisions of "ERPXE:Installation"

From ERPXE Wiki
Line 29: Line 29:
  
 
=== For Virtual Appliance ===
 
=== For Virtual Appliance ===
* to Enable the appliance DHCP please read [[ERPXE Virtual Appliance - How to Enable DHCP]]
+
* to Enable the appliance's DHCP please read [[ERPXE Virtual Appliance - How to Enable DHCP]]
* Update the gateway in ERPXE to your current router/gateway.
+
* Update the virtual appliance's gateway to your current router/gateway.
 
* ERPXE IP address is 10.0.0.1. To change it you should read [[Change IP]] article.
 
* ERPXE IP address is 10.0.0.1. To change it you should read [[Change IP]] article.
  

Revision as of 22:27, 12 December 2011

Appliance Installation

ERPXE software is pre-installed and pre-configured for trouble free deployment.

The Appliance is based on CentOS Mini Linux using VMware Hypervisor.

A Microsoft Hyper-V and Oracle VirtualBox versions will be released further this year.

  • Microsoft and Hyper-V is trademarks of Microsoft.
  • Oracle and VirtualBox is trademarks of Oracle

Custom Installation

ERPXE can be installed on every plaftform supporting TFTP. common daemons are for Linux, Windows and MacOS.

read the following articles for your installation:

NOTE: Some modules are not supported by Windows/MacOS due to limitations.

ERPXE - Custom Install on Linux

ERPXE - Custom Install on Windows

DHCP Configuration

if you are setting a custom installation or you already have an DHCP service on your network you should Configure your DHCP server to use ERPXE. read Configure your DHCP for more information.

For Virtual Appliance

Choosing a TFTP Service

read Choosing a TFTP Service for help choosing your TFTP Service.

Configuring ERPXE

Check the POST-Installation info for your downloaded version or within the doc folder inside your distribution.




That's it. enjoy ERPXE.